It is currently Sat Oct 21, 2017 2:26 pm

All times are UTC - 6 hours [ DST ]


Image



Post new topic Reply to topic  [ 21 posts ]  Go to page Previous  1, 2
Author Message
 Post subject: Re: MEC9000 center punch adjustment... hard to get at it
PostPosted: Tue Aug 22, 2017 7:29 pm 
Shotgun Expert
Shotgun Expert
User avatar

Joined: Tue Feb 21, 2006 8:20 pm
Posts: 10116
Location: Alvin, Texas
Pickman wrote:
DLM - Intriguing idea. Since you didn't mention anything to the contrary, I assume that the projections on your tool will fit in whatever space there is between the crimp punch and the cam. When I look at my 9000 there is virtually no space there. I doubt a .035 inch projection would fit through but I didn't go hunt down my feeler gauges to find out for sure.


Actually there is a bit more wiggle room there than is apparent. You will find that the cam plate will easily push aside far enough to let the projections pass by. The close proximity of the cam to the punch is why I limited the width to the .035 inch like I did. However if you made them any narrower, they would be too fragile and would probably break off easily.

DLM



_________________
DLM


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 21 posts ]  Go to page Previous  1, 2

All times are UTC - 6 hours [ DST ]


Who is online

Registered users: 65panhed, Bass3, Basstar, Bing [Bot], cclark31, ChrisLunker, cookoff013, Curly-Nohair, df, FullTang, Google [Bot], Google Adsense [Bot], gthudspeth, kyskeet, MAJENKINS, Majestic-12 [Bot], Mattmatt300, McFarmer, mw30cal, NCMikeR, outdoorbum, powerserg31, queevil, rdec873, remdog1187, Road Man, RPD63, trdjohn, Turkinator, VTHokiesDuckHunter, WAGinVA


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© 2017 Carbon Media Group Outdoors    - DMCA Notice