Shotgunworld.com
http://www.shotgunworld.com/bbs/

H&R Pardner Pump mag extension
http://www.shotgunworld.com/bbs/viewtopic.php?f=7&t=309530
Page 1 of 1

Author:  bootstrap [ Sun Oct 07, 2012 9:14 pm ]
Post subject:  H&R Pardner Pump mag extension

I'm looking at getting an H&R Pardner Pump Compact for HD and was hoping to get some information about adding a mag extender to it. Would an 870 2 shot extender fit? Anyone have any experience with these guns?

Author:  Rcarrillo45 [ Mon Oct 08, 2012 2:54 pm ]
Post subject:  Re: H&R Pardner Pump mag extension

it would be too long you are going to have to custom make one there is a great vid on youtube looking it up the only thing i would to different is braze it when all done just to make sure it never fails

Author:  kingjoey [ Wed Oct 10, 2012 3:07 am ]
Post subject:  Re: H&R Pardner Pump mag extension

The 870 mag extension should fit, might require some modifications, but it should fit. I would highly recommend using the factory Rem870 extension on this, it'll give you a little flexibility to allow a precise fit. Give us a call at 615-568-7901 if you have any technical questions, we've put mag extensions on just about anything

Author:  kilrain_20th [ Sat Oct 13, 2012 10:40 am ]
Post subject:  Re: H&R Pardner Pump mag extension

I used a Scattergun Tech/Wilson, one shot 879 extension on mine and it's great, no modification needed. Adds one round of capacity to the tube and just a bit shorter that the stock barrel. The quality is top notch and the finish matches the Pardner Pump very well.

Good luck!

Author:  bootstrap [ Sat Oct 13, 2012 10:48 pm ]
Post subject:  Re: H&R Pardner Pump mag extension

Thanks for the advice

Author:  62-10 [ Thu Oct 25, 2012 8:51 pm ]
Post subject:  Re: H&R Pardner Pump mag extension

A Royal Arms +1 mag extension for an 870 will fit your Pardner Protector. You will lose the OEM mag cap sling stud, though.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/