Shotgunworld.com

SEE NEW marked with red.

MAJOR Note:
PM system sometimes fails to notify recipients, for now, so any queries should be by email direct:
kirbythegunsmith@hotmail.com
Thanks.
Kirby
------------------------
Major revisions and additions with new pictures soon.
These are some of the firearms that I will need to sell for the Widow of a long-time acquaintance and friend.

Any particulars can be discussed by either emailing your phone# and/or calling the number posted on my website. Barrel prices are lower than you would get at the well-known resellers out there.

kirbythegunsmith@hotmail.com

There are a number of classic and Browning single shot rifles for disposal, too, and they start at .22 Hornet and went up to a Quigley 45-120 Sharps 1874 (sold to a satisfied customer, now).

Partial list: Browning B-78 or 1885- 22-250, .243, 25/06, .260, .357, 38/55, .45 Colt, 45/70
Many of these have dies to fit, some have shell components or boxes of ammo, like the 45/70 having 6 boxes of factory shells, hundreds of commercial cast and jacketed bullets, dies, and spare brass. There was over 70 sets of dies in his reloading area.

One 1885 had been rebarrelled heavy octagon to .33 WCF (basically a necked down 45/70 and predecessor to .338 Mag.) and included some brass, dies, etc (SOLD)

Springfield KRAG 1898 30-40 bolt carbine, looks very clean, possibly unissued

Ruger #1, .223 .....Uberti 1885, 38/40 ....
Remington Rolling Block (Italian made copy, evidently Uberti etc.) w/octagon barrel in 50/90 (re-chambered from 50/70, both sets of dies, plenty of brass and over 20 lb. of comm. cast (350 new bullets)

This A-5 Classic 1 of 5000 is one of them already noted (sold).
viewtopic.php?f=74&t=212986

Magnum 12 Belgium 30” FVR, solid wood has marks, minor surface spots, scratches on blue of this classic waterfowl gun, 2 piece carrier, bore still mostly shiny, tiny 3/8” repaired wood crack at rear of top tang, pad at 14”



NEW
Browning A-5 pre-war 16 ga. Belgium, satin wood and metal finish. Wood is solid with a few patches of visible dents, metal is fairly clean with sharp engraving. 27-1/2" vented Polychoke plain barrel.






NEW
American Browning 12 ga. 28" plain MOD, been re-finished, has a couple minor cracks at the rear underside of the forend.



This has been sold, and the new owner has posted he is happy with this below.
20 ga. 26” Mod. matted barrel, been reblued, refinished, minor marks, tiny forend crack repaired before finish, another 2” long repaired split, 2 piece carrier, bore still shiny



NEW ADDITIONS
Some barrels pictured- from the top:
1. 20 ga. 26” cut to 25” w/new Invector choke hole in straighter than factory, (pictured w/steel tube installed in hole to 27") long forcing cone, clean in and out with little use. Test-fired dead-on point of impact on the 20 ga. gun sold below.
2. 20 ga. MAGNUM Japanese 28" Full Vent Rib, pretty clean w/ shiny bore and chamber
3. 16 ga. Belgium matted 28” full, reblued, couple handling marks and small blemish pits at muzzle
4. SOLD Pending funds 16 ga. INVECTOR 26" vent rib, has little use (not even developed forend rubbing marks) with a few faint external marks, some minor bore/chamber imperfections but otherwise has a great shine inside and out
5. 12 ga. std. Japanese Buck Special, looks testfired only, as new otherwise, $325 shipped
6. 12 ga. 30” full VR Japanese, little use, 1-1/2” forcing cone, shiny bore
7. 12 ga. Solid Rib Belgium CUTTS, ~28" with MOD tube installed
8. SOLD. 12 ga. Belgium plain 28" MOD, been polished
9. 12 ga. Mag. Invector cut to 25.5” w/new straight hole, long forcing cone, has steel-shot choke in picture to 28” overall length, clean inside, few scratches outside, little use
10. 12 ga. Mag. Invector 30”, long forcing cone, steel-shot choke shown in picture to over 32” overall length, shiny bore, little use with minor external scratches


Thank you for looking.
Kirby

Some good stuff there. Prices?

Email sent on #3 16 gauge, mod choke barrel. Consider it sold. Thanks

sold invector choked light 12 will send money order ASAP

money order and FFL are on the way how much for the 7 mag high wall

List has additions and is edited for things no longer available.

Kirby

thanks for the nice A5 light 12

Is the 20 ga barrel still available? if so price

thanks

I noticed you posted a .45 colt and a 7mag. I was wonderin
How much for each of those if you still have them and if you can send
Me a few pic of them. My email address is jr.riley88.jr@gmail.com.
Ty

curious about the 22-250 the 243 the 357... are they all single shots? all brownings? any info would be great. Thanks

What are you asking for the A5s?

I am curious about the #6 barrel. I am looking for a invector barrel for a Browning A5 light 12.

got the #6 A5 barrel. It's very nice, just like advertised. The price for this barrel was very good, more than fair. Thank you.

I realize this is kinda late in the game...
is that 20 ga 26" mod still available? If so the price is???
chuck194494XXATXXhotmail.com
Replace XXATXX with @

Thanks,
///olde pharte///
You can PM me or use email

20 ga A5 was picked up yesterday. Gun was exactly as described. First 20 ga A5 I ever handled... NICE balance and fit me well. Felt nothing like the 12 ga A5
I'll try to kill a tin can or a milk jug tonight.
Gun was certainly better than picture showed.
///olde pharte///

What is the price on number 2?

Interested in barrel #1: A5 20ga with choke. If it fits my A-5 20ga (2.75", not a "light-twenty, just a "twenty"), I'd like a price quote. Send email to drstrangelove99 at comcast dot net

How much for the Krag?

Newest stuff just listed on 11/21 is marked with red.

Kirby

Price for

4. 16 ga. INVECTOR 26" vent rib, has little use (not even developed forend rubbing marks) with a few faint external marks, some minor bore/chamber imperfections but otherwise has a great shine inside and out


please.
Thanks