Shotgun Forum banner

cutting a barrel and rethreading choke

1K views 2 replies 3 participants last post by  GordonWood421 
#1 ·
Well, the title says it. Can any gunsmith cut and then rethread for Invector Plus or does this have to be sent out?

Edit: I am just wondering if I should buy the short barrel from Browning or if I could pick up a longer one from Ebay or something for a lot less $$ and still use all the chokes I have.
 
#3 ·
mossytxn ,

A5guy's recommendation of checking with Mike Orlen is spot-on .

You might consider examining the last 6" or so of your barrel to see if some of the section is somewhat divergent to allow for the larger diameters of the Invector+ CT design . If so , the probability of being able to recut for + tubes may not so good --- but for another , maybe thinwall type , maybe OK .

Mike will know and do a good job --- of course , if you have the funds , Briley will go where others choose not to venture for good reasons .

421
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top