Shotgun Forum banner

Browning Ejector Springs

710 views 0 replies 1 participant last post by  railroad 
#1 ·
I had the metal off the forearm of my 725. Upon trying to re install it, I dislodged one of the ejector spring-pins. Now I cannot get the spring and pin back in place. I removed the block that holds the pins and springs, so both springs and pins are loose, more to figure out.
Not being able to easily reassemble, I read the post on ejector to extractor mod on Brownings.
The part about being able to convert in the field on the shooting line in minutes, gave me confidence there is an easy method to assembly.
I cannot get the spring to compress with the pins and back into the appropriate notches and holes.
I have some firing pin pliers, but so far, unable to get them to do the job.
I have walked away and let mental state reload.
Any advise on doing this without disassembling the ejector sears and cams?

GOT IT! just needed to back off and think.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top