Mid-Bead to Replace Front Bead

VTCTGarrett · **Joined:** Mon Jul 27, 2015 6:48 pm **Posts:** 6

I am stepping up to an Invictus V and my previous Guerini I had replaced my front bead with a mid bead sized bead (about .067” in diameter) and would like to do the same with my new gun. I remember previously I had gotten the beads off of brownells but have since been unable to find a mid bead in a 3mmx.05 thread pattern. Does anyone have a lead or an idea of where I could find one that would fit? Thanks.

lt0026 · **Joined:** Thu Jul 31, 2008 11:12 am **Posts:** 5697

http://www.marblearms.com/shotgun-beads.html

http://nebula.wsimg.com/43ff1d0e0a101d5 ... oworigin=1

oinodam · **Posted:** Tue Sep 01, 2020 6:47 pm

VTCTGarrett - At some point about two years ago, I completely removed all beads from my guns. I haven't missed or needed them at all. To have them means you may (will!) look at them while shooting, and that is always bad. I still fight "measuring" like a crack addict fights using.

MAJENKINS · **Posted:** Wed Sep 02, 2020 6:01 pm

Measuring--sigh. Taking off the beads is a great idea. But if I could only find some "invisi-noleum" to coat the barrels with. MAJ

VTCTGarrett · **Joined:** Mon Jul 27, 2015 6:48 pm **Posts:** 6

oinodam- I will probably go this route if I cannot find a small mid bead sized bead to replace the snow globe at the end of the barrel. Incredibly happy with the gun and the way it handles, however the bead proved to be a big distraction. It may be the no bead life for me!

Mid-Bead to Replace Front Bead

Who is online