Shotgunworld.com
https://www.shotgunworld.com:443/bbs/

410 STS Hulls
https://www.shotgunworld.com:443/bbs/viewtopic.php?f=13&t=4689
Page 1 of 1

Author:  lamo841 [ Wed Aug 27, 2003 12:21 pm ]
Post subject:  410 STS Hulls

I'm trying to reload Remington 410 STS hulls.
I've tried reloading them on both a Mec 650 and 9000G.
I'm using 15 grains of 296 and have tried Remington and Winchester wads including the new red ones. All the crimps are way too deep to the point that the shot falls out. It's like the wad needs to be taller. AA hulls work just fine.........Anybody else experience this problem?

Author:  20 gauge #1 [ Sun Sep 14, 2003 12:20 pm ]
Post subject:  Re: 410 STS Hulls

are the remington shells 3" and the AAs are 2.5"???

Author:  greyghost [ Wed Sep 17, 2003 4:15 am ]
Post subject:  Re: 410 STS Hulls

You either need to go to a bulkier powder or a filler wad in the shotcup,or a different wad, regardless the small gauge hulls (28's and .410's ) are alot fussier than 12's or 20's IMO

Author:  Jersey Hunter [ Thu Sep 18, 2003 10:31 am ]
Post subject:  Re: 410 STS Hulls

Did you weigh the powder and shot? Thats the load I use with Remington wads and I had to go back and recrimp about half of them because the crimp was starting to open like they had too much in them. If the weights are correct you'll have adjust your crimp depth.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/