ndgregor1 wrote:
The only visual difference between the two to me is where the roller is positioned. .
Thats all there is.
ndgregor1 wrote:
Station 1 - I continually get significant flaring and sometimes rolling over of the open shell end during deprime and resize. Is there an adjustment for this?
Yes unscrew the resizer die from the die head, the deprime punch is then adjustable on its threaded shaft.
ndgregor1 wrote:
Station 3 - often times the wad does not seem to want to go down without a decent amount of force. Is this normal for .410?
No, could you be cocking the wad on the way in??
ndgregor1 wrote:
Also, on occasion the wad wants to pull out when I left the lever after dropping shot. I’m not using wad pressure but have confirmed the wad is being placed directly on top of the poweder
Pause at the bottom to assure that its not trapped air pressure pushing it up.
Polish and wax the OD of the drop tube so the wad slides off.
Steve