Does anyone have load data for a 1and1/8 ounce trap load Using Titegroup and Federal Hulls
Ive read I need to use the 12s0 wads to make this happen but wanted to make sure.
Thanks

I cannot find any Federal hulls using Titegroup and any amount of shot in the normal places....manuals or internet. It seems that it should work, but very little data.

Hodgdon does have a few target loads using Titegroup in Remington and Winchester hulls but nothing for Federal.

Sometimes when there is no data there is a reason.

I would at least give Hogdgon a call.

Go to the Federal reloading data.... listing for Titegroup in "Plastic hunting case" for 2 3/4" hull. Only show one load at 1255fps..... Larry

I have used this load in Fed paper base wad hulls only, 19.5 grains Titegroup, 12S3 wad, Fed.209A primer, & 1-1/8 oz. of shot, this looks like the load llc is looking at.