 
|
Page 1 of 1
|
[ 4 posts ] |
|
| Author |
Message |
|
psparks60
|
Post subject: Buttplate for pre-1911 Remington Autoloading Shotgun c 1907  Posted: Tue Dec 29, 2020 10:11 pm |
|
Joined: Fri Jul 24, 2020 11:33 pm
Posts: 5
|
Perhaps someone can advise me on the 'correct' buttplate for my c1907 RAS SN: 44xxx? I have found a few earlier posts here that suggest it may be one of two: Remington/Arms Co (semi-circle) or Remington/Automatic (semi-circle). Thanks in advance.
You do not have the required permissions to view the files attached to this post.
|
|
| Top |
|
 |
|
CriscoKid
|
Post subject: Re: Buttplate for pre-1911 Remington Autoloading Shotgun c 1 Posted: Wed Dec 30, 2020 2:40 pm |
|
Joined: Mon Jul 05, 2010 7:16 pm
Posts: 3527
Location: New England
|
. Welcome to SGW ! !  The correct BP for your gun is the lower pic above. Only the very early production pre-model 11's had the automatic BP logo. The subject was discussed here: https://www.shotgunworld.com/bbs/viewto ... 5&t=403386.
_________________
["CriscoKid", alias: Fat in the Can]
|
|
| Top |
|
|
|
psparks60
|
Post subject: Re: Buttplate for pre-1911 Remington Autoloading Shotgun c 1 Posted: Wed Dec 30, 2020 3:24 pm |
|
Joined: Fri Jul 24, 2020 11:33 pm
Posts: 5
|
|
Thank you Cisco. Great info!
|
|
| Top |
|
|
|
psparks60
|
Post subject: Re: Buttplate for pre-1911 Remington Autoloading Shotgun c 1 Posted: Wed Dec 30, 2020 3:59 pm |
|
Joined: Fri Jul 24, 2020 11:33 pm
Posts: 5
|
|
Curiously, my stock measure 1-3/4" wide exactly, whereas the repro buttplates are spec'd to be 1-11/16 and 1-5/8, respectively, which makes the "Automatic" a better but not perfect fit. BTW the marks on the stock are the same as on the gun, so not sure why it is thicker than the available plates. I may need to just go with something else.
|
|
| Top |
|
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Login
Register
Chat [1]
Calendar
Photos
FAQ