 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
LUGNUTZ426
|
Post subject: 1187 forend on 1100  Posted: Wed Feb 17, 2021 10:25 am |
|
Joined: Fri Feb 24, 2006 8:00 pm
Posts: 331
Location: NY STATE
|
I am going to use a set of 11-87 wood on an 1100. The forend locking system is different. The choices are install an 1100 forend steel insert with the detent ball and use an 1100 cap or possibly install an 1187 mag retainer with the serrated end and use an 11-87 cap. Has anyone done the deed and had success . Is there another alternative, possibly installing a detent ball alone in the end of the 11-87 forend? Thanks
_________________
1187,1100,LT-20, 300 IDEAL, 870,WINGMASTER,700,760,788
ALL MADE IN THE U.S.A.!
|
|
| Top |
|
 |
|
casonet
|
Post subject: Re: 1187 forend on 1100 Posted: Wed Feb 17, 2021 11:11 am |
|
| *Proud to be a* |
 |
 |
Joined: Mon Jul 20, 2009 1:54 pm
Posts: 12169
Location: Kansas
|
I have the 1100 steel insert tubes new old stock if you need one. And yes, I have installed them: very simple. [email protected]
_________________
"We pulled the trigger, the safety went forward, both barrels fired almost together, the gun opened, ejectors kicked the fired cases over our shoulder ...the most completely automatic gun we ever fired" Elmer Keith- Shotguns by Keith
|
|
| Top |
|
|
|
Virginian
|
Post subject: Re: 1187 forend on 1100 Posted: Wed Feb 17, 2021 9:33 pm |
|
| *Proud to be a* |
|
 |
Joined: Mon May 19, 2008 8:20 pm
Posts: 14416
Location: Williamsburg, Virginia
|
|
A rubber O ring will secure the fore end just fine. You are probably going to have to shim that fore end.
_________________
What could have happened... did.
I do not trust Remington's dating service accuracy. If they were Match.com, you could end up with Nancy Pelosi.
|
|
| Top |
|
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Login
Register
Chat [0]
Calendar
Photos
FAQ