Shotgunworld.com
https://www.shotgunworld.com:443/bbs/

"New Model" 1100 parts
https://www.shotgunworld.com:443/bbs/viewtopic.php?f=55&t=533772
Page 1 of 1

Author:  J.Fred_Muggs [ Wed Jun 02, 2021 3:55 pm ]
Post subject:  "New Model" 1100 parts

I was able to obtain "New Model 1100" (smooth sides, no engraving) to replace a cracked receiver on my 50 year old 1100.

It works.....worked....until it broke the feed latch. I got the old latch out and it appears the latch was much more securely staked into the receiver.

I obtained an unbroken latch from a old classic 1100.

I'll be darned if I can get it in. Side-by-side to the old latch, it looks the same other than where is broke.

What's the trick of getting it in?

Must I obtain a latch for a "New Model 1100"? Where?

Author:  Virginian [ Wed Jun 02, 2021 6:31 pm ]
Post subject:  Re: "New Model" 1100 parts

The feed latch is unchanged from 1963 until 2020. They do NOT have to be staked in - the pins and the trigger group hold them in the proper place. Sometimes the old staking may interfere with insertion of a new latch. Try to wriggle it in there. You may have to bend the old staking a little.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/