Shotgun Forum banner

Beretta AL 391 Urika 2 bolt release assembly.

1K views 5 replies 3 participants last post by  Gr shooter 
#1 ·
Hallo to everyone,

i have the Al 391 Urika 2 for 8 years now and i like it a lot.
As i was cleaning the receiver from the inside i pushed the bolt release assembly a little and i felt that it has a " play, up-down "- the inner long part -not too much, but it sure has.
I do not know if thats normal or it is some kind of wear. Please advise.
The gun operates normal.

Thank you for your time to respond and your help.
 
#3 ·
Sorry that my description was not clear enough.

My receiver is completely empty.....i have removed the trigger group and the bolt assembly.
The assembly that i am talking is the bolt release assembly that is in the receiver and has the bolt release button attached on the outside. The inner long part with the spring is the one that has the small up-down movement. Please advice on this, normal or not ?

There's one for sale on ebay https://www.ebay.com/itm/353262905402?m ... olid=10001

Hope this helps, thank you again.
 
#4 ·
If your gun functions fine with no hiccups, leave well enough alone.
 
#5 ·
Gr shooter said:
Sorry that my description was not clear enough.

My receiver is completely empty.....i have removed the trigger group and the bolt assembly.
The assembly that i am talking is the bolt release assembly that is in the receiver and has the bolt release button attached on the outside. The inner long part with the spring is the one that has the small up-down movement. Please advice on this, normal or not ?

There's one for sale on ebay https://www.ebay.com/itm/353262905402?m ... olid=10001

Hope this helps, thank you again.
I believe this is the normal condition of bolt release assembly...there is no wear.

The proof is the gun functions normally, so it's all good.
Enjoy!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top