Shotgunworld.com
https://www.shotgunworld.com:443/bbs/

Model 12 Adjusting Sleeve Lock- how to replace?
https://www.shotgunworld.com:443/bbs/viewtopic.php?f=60&t=520076
Page 1 of 1

Author:  bczrx [ Sat Oct 03, 2020 9:12 pm ]
Post subject:  Model 12 Adjusting Sleeve Lock- how to replace?

Hello,

Is there ANY way to replace the adjusting sleeve lock on the Winchester Model 12 without unscrewing the barrel from the extension itself?

I found one that doesn't have a lock in the extension, but the extension/barrel are fitted.

I have a lock for it, but have no clue how to insert it.

Anyone have any ideas?

thank you

Author:  winmod21 [ Sun Oct 04, 2020 5:00 pm ]
Post subject:  Re: Model 12 Adjusting Sleeve Lock- how to replace?

Check out the Model 12 assembly/disassembly post above. Also may post in the gunsmithing and repair forum.

Author:  bczrx [ Sun Oct 04, 2020 6:15 pm ]
Post subject:  Re: Model 12 Adjusting Sleeve Lock- how to replace?

winmod21 wrote:
Check out the Model 12 assembly/disassembly post above. Also may post in the gunsmithing and repair forum.



Thanks.

I read through the assembly/disassembly post and learned a lot, but either I missed the removal/replacement of the sleeve lock, or it isn't there. I remember reading about moving the lock while making adjustments to the sleeve, or replacing the sleeve. But, nothing on the lock itself.

I will ask in the gunsmith area.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/