Shotgunworld.com
https://www.shotgunworld.com:443/bbs/

Easy 10$ 20minute improvement to closing SPR310x
https://www.shotgunworld.com:443/bbs/viewtopic.php?f=83&t=88348
Page 4 of 4

Author:  Afzaal [ Thu Oct 04, 2012 10:48 pm ]
Post subject:  Re: Easy 10$ 20minute improvement to closing SPR310x

12GAUGE-PAKGUNS wrote:
@Wee Hooker

will the manual safety still work after you cut the metal bar?

Regards.


yes bro manual safety would still work.

Author:  dbuffington [ Fri Sep 13, 2013 8:18 pm ]
Post subject:  Re: Easy 10$ 20minute improvement to closing SPR310x

Patrick Randall wrote:
If your IZH-27 or SPR310 is like mine was, you need quite a bit of strength when closing the gun to overcome the ejector/extractor springs once the lugs on the extractors (2 & 3) engage the slots on the inside of the receiver. I didn't particularly mind this except the force required to overcome was causing the gun to close quite hard. I don't know if that's a good thing or not long term. After this 20minute mod it is soooo much easier to close.


I know this is an old, old thread, but still, it's incredibly useful. I just fixed up a friend's IZH, and it's MUCH better now. Thanks to Pat and all who contributed!

Yours,
Dave

Page 4 of 4 All times are UTC - 6 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/