Shotgun Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter · #1 ·
I have a 30'' 101 trap with full and Improved Mod. Diamond Grande.
What I need to know will a single barrel trap fit up without any special gunsmithing.
Also, what is the standard length on firing pin protusion from the tip of the pin to the face of the reciever. Thanks Bill
 

·
Registered
Joined
·
432 Posts
M-m-m-m-m,
.052 sounds like a bit much to me!

Ray
 

·
Moderator
Joined
·
1,203 Posts
As a rule, firing pin protrusion should be aprox. .055"...much less than that and you might run into unreliable ignition; much over .060" and primer punctures and pin retraction timing problems will occur.
 
1 - 4 of 4 Posts
Top