Shotgun Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter · #1 ·
Opened the Goose Season in PA on Thursday. While shooting at the first group of decoying birds, my older 1100 did not cycle. First shell fired, but didn't eject. The bolt stayed closed. Test fired later with same results, but when I manually loaded a single shell, it fired and ejected. When home, I disassembled to see what was wrong. Everything was cleaned previously, but I cleaned and lubed again. When running empties through the gun to test it, it would load correctly, but upon pulling the trigger, I could not manually operate the bolt. Forcing the bolt back ejected the first shell and the second chambered, but again, the bolt was sticking. I'm not sure if it is related, or me being over sensitized, but it seemed to require more travel from the carrier release to get the bolt to slam home when loading. Any insight is appreciated.
 

·
Registered
Joined
·
78 Posts
Discussion Starter · #4 ·
After careful inspection of the action bar assembly, everything appears ok. Nothing broken or overly worn. I did notice a corner of the hammer appears to be sheared off. I will replace the hammer and spring, but was wondering, would the hammer interfere with bolt travel? I will also replace the worn bolt buffer. Should I also replace the slide block buffer? This was a used, not well maintained magnum gun that saw heavy use. I have been shooting and maintaining it for about seven years, but now think it's time to start replacing some parts.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top