Shotgun Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
The trigger guard on my Beretta 3901 20ga broke, so I mail ordered a new trigger guard from beretta.

Can anyone tell me where can I find directions on changing all the assembly parts from one guard to another?

There are no good Gunsmiths here in Panama, and I am mechanical inclined.

Thanks, and Merry Christmas....
 

·
Registered
Joined
·
30 Posts
If you tap the trigger pin out of the receiver, the whole trigger assembly comes out in one piece. I assume that the guards are interchangable and should not be too tough. Getting the assembly out without the guard on it will be a little tricky, as its the guard that I pull on to get mine out.

Good luck.
 

·
Registered
Joined
·
9,154 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #4 ·
Thanks for the help.... I was able to change it without problems.

Can anyone tell me if I could use a 391 trigger guard on my 3901???? using the assembly parts of my 3901...
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top