Shotgun Forum banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
:lol: 391 comes with.25 shim spacer. lowest i can find is .65 anyone know of a lower one ??
 

·
Registered
Joined
·
6,000 Posts
You can double up on the spacers to get a greater drop on the comb. There is some risk in this as there is the potential to bend the recoil spring tube which will affect the ejection and feeding of rounds. You can alleviate the risk by enlargening the washer that goes into the stock in the correct direction. You may be able to accomplish the same goal by switching to a field stock if you currently have a parrallel or raised stock. The last option is to sand a small amount off the comb until you reach the desired drop.
 

·
Registered
Joined
·
1,500 Posts
Two more suggestions. There is a little play in the washer in the butt stock, and if you place downward pressure on the stock whil you tighten the bolt you will pick up two or three millimeters. Further, in this regard, at 65mm you are down about 2.5 inches (drop to heel), and if you lengthen the LOP that will continue to make the heel drop lower.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top