Shotgun Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1,058 Posts
Sad as it may seem......When these splits show up and cut-offs around the top of the brass happens....it means the factory is trying to pump up profits by increasing the ammount of regrind plactic in the hulls. If you have read my posts concerning factory attitudes you will understand. Any field man that has the "I don't give a d*nm" attitude should be given his walking papers at once. I would have fired him on the spot. There are times a factory makes an honest mistake! It's the field man that picks up the problem at ground zero and has the option to send it all back for replacement. That's how the consumer builds trust in a product.
My suggestion is buy some other product.....the factory will get the word! Forget brand loyalty! Best Regards, James
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top