Shotgun Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
301 Posts
Discussion Starter · #1 ·
the top lever on my browning 410 is hard to open it has 500 rounds through it cannot see anything binding,,,,the other guns on the rack were much easier to open i chose this one because it has real nice wood...when bbls are off it works fine and when assembling it the lever centers when it closes but after you fire and reload and close it does not center all the way....any thoughts?????????
 

·
Registered
Joined
·
17,956 Posts
It isn't supposed to be centered, it should be a bit off to the right. A Browning will wear in a bit. Make sure there is no dirt or burned powder between the extractors and the barrel assy, that there is no crud in the notch for the locking tab and nothing between the barrels and the reciever to make the fit snug. Keep a little light grease on the locking lug and notch and fire away. The lever should not be cented, nor should it be 1/2 way to the point that the barrel wants of open either. Clean and lubed are good choices!

BP
 
1 - 2 of 2 Posts
Top