Shotgun Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2,705 Posts
No, but I have two pounds of it. I was going to use it but then I decided to wait until I ran out of Clays. That should happen sometime before the end of the year :roll:

For that matter, I don't even see it on Alliant's website and it's even still talking about 'new' e3.
 

·
Registered
Joined
·
1,656 Posts
What's the story on this new Claydot? I heard that it's out there (one of our local shooters brought back some promotional shells loaded with it from the Grand) and is supposed to compete with Clays. But aren't e3 and Red-Dot already in pretty much direct competition with Clays? What's Claydot supposed to do, that the other two Alliant powders don't?

Michael
 

·
Registered
Joined
·
2,705 Posts
Slick13 said:
What's Claydot supposed to do, that the other two Alliant powders don't?
It's an exact drop in replacement for Clays. Uses the same bushing and the same mass to produce a given load from a given hull, primer, and wad. Made in a America vs. made in Australia for Clays. Supposed to be a little cheaper than Clays, too, when it is introduced.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top