Shotgun Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,688 Posts
No, but I have two pounds of it. I was going to use it but then I decided to wait until I ran out of Clays. That should happen sometime before the end of the year :roll:

For that matter, I don't even see it on Alliant's website and it's even still talking about 'new' e3.
 

·
Registered
Joined
·
2,688 Posts
Slick13 said:
What's Claydot supposed to do, that the other two Alliant powders don't?
It's an exact drop in replacement for Clays. Uses the same bushing and the same mass to produce a given load from a given hull, primer, and wad. Made in a America vs. made in Australia for Clays. Supposed to be a little cheaper than Clays, too, when it is introduced.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top