Shotgun Forum banner

Depriming problem

678 Views 1 Reply 1 Participant Last post by  SockPuppet
I'm having a problem with my shells getting a large bulge out the bottom of the brass when depriming. There is a lot of resistance once the depriming rod makes contact. The hulls are Winchester Super-X 10 gauge steel once fired factory loads.

For kicks and grins I stuffed a 12 gauge 2 3/4" Winchester AA (grey) hull in the depriming station and it popped out the primer no problem and no bulging of the head.

Press is a MEC Steelmaster for 10 gauge.

So any ideas what's going on?
1 - 2 of 2 Posts
Never mind...

I discovered I was missing the insert that goes in the bottom of the resize chamber... Doh! :roll:
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.