Shotgun Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
2,705 Posts
Discussion Starter · #1 ·
The title says it all....

What is the diameter of the stock retaining nut on a 391 Urika? I know it's something metric but from there I'm stuck since I do not have a full set of metric sockets.

Thanks.
 

·
Registered
Joined
·
419 Posts
I am pretty sure it's 13mm,which is close to 1/2" in old money.
 

·
Registered
Joined
·
2,705 Posts
Discussion Starter · #4 ·
albanygun,

Thanks for the reply. I'll have to go to the hardware store and see what size wrench is necessary for a nut threaded for 8mm.
 

·
Registered
Joined
·
2,705 Posts
Discussion Starter · #6 ·
dgarnier,

Thanks for the reply. You were right. I solved the problem by buying a full set of metric sockets from 9 - 19 mm (Craftman was on sale for $22).
 

·
Premium Member
Joined
·
19,997 Posts
albanygun said:
What is the thread size of my 390/391 stock bolt ?

Answer
The bolt for the Model 390/391 is threaded to 8.0 mm x 1.0 mm
Albanygun,

Your answer is correct. It's just not the answer to the question that was asked by Bopper. :wink: The numbers 8.0mm x 1.0mm refer to the diameter and the pitch (spacing) of the threads on the bolt, not to the size of the head on the bolt. The head size, as stated above, is 13mm. :)
 
1 - 7 of 7 Posts
Top