Shotgun Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Has anyone had any experience with the Tactical Ghost Ring sight kit from Precision Sights International? I was considering putting them on my Mossberg 590, Model 50660 (Parkerized 9 shot with the heat shield) to replace the bead sight. I am guessing that the receiver would have to be drilled and tapped for the rear sight but supposedly the front sight simply slips over the end and clamps on. I'm concerned that the front barrel support might be in the way however. Any opinions? I want Ghost Ring sights and Mossberg says their kit won't work with the heat shield.
 
G

·
The will have to be D&T regardless as you know, but with the front sight you will have to with a ramp only, I would recommend going with the GHOST RING SET from SCATTER GUN TECHNOLOGIES, THE FRONT RAMP is epoxied or your front bead and holds quite well , I have installed theses on a few 590's in the past for some 3 gun shooters .RON KONTOWSKYACTIONS BY R.A.K.8o
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top