Shotgun Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
118 Posts
Discussion Starter · #1 ·
I acquired a Mec Grabber 761 R2 20g in a package buy. I don't load 20g, so I'm cleaning it up and replacing parts in order to sell it. One of the parts I'm replacing is the reprime spacer that goes above the lower reprime spring. The manual shows the part# 8341, but when I checked Gamaliel's they only show 1 spacer and that is # M8344. Does anyone know if these are one in the same?

Cannon Cocker
 

·
Super Moderator
Joined
·
9,914 Posts
The reason for the parts # difference is the 761/2R Grabbers are now discontinued and their part #s have been replaced with the #'s from the 8567 Grabber. Order the 8344 as Curly said.

Steve
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top