Shotgun Forum banner
1 - 1 of 1 Posts
G

·
Discussion Starter · #1 ·
I'm trying to replace the missing hammers on my Dad's old double gun. It is much wider at the grip then any other I've seen. I've found a lot of hammers but they all sit wide of the firing pins. Gun will be a wall hanger only, sears and springs are shot. I did my part wearing this old shooter out. No information but A Richards 12 Gauge on the barrels. Under the barrels on the receiver is stamped: 21186 either AZ or A7-47 then 12 Belgium. Is this a rare type of gun with the wider grip? and from this information is it likely a Damascus Barreled gun. I was putting low brass paper then plastic shells through it regularly in the 70's. Thanks for any help
Dave Blackburn
[email protected]
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top