Shotgun Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2,345 Posts
Hello slinky: I'll assume you mean the magazine tube plug that restricts the mag tubes capacity?

There is a round pin at the end of the mag tube, get a small flat nose screw driver, push the pin down until it protrudes fron the other side. You may have to rotate the pin but there is a small slot in it for a flat spring. Usuing the flat nose screw driver CAREFULLY place it into the slot ant push the sprng down, pull the pin out with your free hand. Now that the pin is out you can see the little tab on the end of the spring. reverse the pin and put it vack into the hole about half way. Now using your small flat nose screw driver, remove the 2 screws, on on each side of the mag tube holding the mag tube plug and stop. Now that the two screws are out. Put one finger on the end of the mag tube to hold the mag tube pub and stop. Pull the pin out, you may have to wiggle the plug and stop to get it to move some but it will come off. Now you will have the mag tube spring sticking out of the tube. just pull it out and remove the plug. I recommend that you tip the gun up so the follower comes out too! Clean the tube like you clean the barrel and oil it down, clean the follower and spring. reassemble in the reverse manor.

Regards Dave
 
1 - 3 of 3 Posts
Top