[28 ga kid]

i need to reset an innotek adv 1000 e collar id and i cant find my manual i looked on the web site from the mfg i must be missing a step i did it 10x still it doesnt work.i put collar on my dog for opening day she thought it was working im lucky that shes not a hard headed dog like others have where you hear owners screaming at all day

 

[Epointerz]

From the manual for the ADV-1000P. Press and hold ID button for 3 seconds. The display shows prog and scrolls through numbers, then goes blank. A new code has been selected. Match the collar to the transmitter. Hold the red dots together, until the collar glows green then amber. Press transmitter button, receiver led will glow red.

 

[28 ga kid]

thanks ,i tried that .i was off this week so i called mfg they ran me thru the reset sequence 3 ways either collar or controller is bad and no repairs or trouble shooting available w/ the prorated replacement its the same price i paid lion country 3 yrs ago that doesnt seem right i was hopeing to send unit back and replace componant that was bad i really liked this system but lack off support wont make me want the same product again

 

[gwp4ever]

Thats Innocrap for you.

 

[birdshooter]

I have the older track and train 1600, and this is the 3rd one as they don't seem to last. The latest is probably the longest stretch going on 2 years. Lucky I bought the 5 year warranty. When they go down they tell me to send it back in and they send me a new one. I just pay a small handling fee. I will say if I had to do it all over again I would not touch an Innotek.

 

[Desertrat]

sometimes I have had to pull the batteries out....wait about 5 minutes and re do the whole sequence.

 

[Swampcollie]

As you're finding out there is a reason a lot of folks call them innojunk.

The design and construction of their equipment make the units not repairable. When something goes wrong, you have to throw the unit away and buy a new one.

Try a Dogtra or TriTronics unit. They cost a little more but can be repaired when you break it.

 

[plowboy1989]

I have one of them. I haven't used it since my lab died almost 3 years ago. I got it out a while back and the red stickers are gone. I have messed with it for hours and haven't been able to find the sequence to get it turned on and off. I too lost my instructions.

 

[28 ga kid]

plowboy 1989 if you want i can dig mine out and tell you where dots are on mine i think its a magnet

 

[plowboy1989]

28ga. That would be great, mine is the 300A model.

 

[28 ga kid]

hold collar on table long strap going to left, buckle on right ,charging hole is on right top the dot was on opposite side upper left about a 1/4 inch from collar. look at remote lower right side corner turn unit sideways you will see seem the rear panel at the radius hope this helps could show you 1 2 3 try and type it seems silly if it doesnt work let me know and ill retry to exsplain