Shotgun Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
1,156 Posts
Discussion Starter · #1 ·
I currently do not reload,however,I thought this would probably be the place to go for this question.I'm looking for,"hopefully inexpensive",factory loads that are relatively low in produced pressure for use in older,lightweight,SxS's.I'm not talking Black powder only proofed guns.I just want to reduce wear and tear on the shoulder and on the guns themselves.I've tried looking on the boxes of name brand "game loads",but no info. on pressures is given.I thought of going to each manufacturers site but decided starting here might save on the precious two fingers that I use for typing :) .12 & 20ga.would be the gauges needed at this point.
Thanks,
Jim
 

·
Registered
Joined
·
109 Posts
Jim,
You might try any of the various subsonic loads available from the major manufacturers. While they were aparently developed to cut down on noise pollution there seems to be a following who use them for their reduced recoil benefits.
 
1 - 7 of 7 Posts
Top