Shotgun Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,575 Posts
Discussion Starter · #1 ·
I am thinking about getting some all brass hull in .410 for reloading. Many years ago I had some Alcan 20 gauge hulls that just would not wear out. I am now loading .410 for skeet only so I think I want to try the all brass route again.

Are there any all brass hull besides Magtech??

Where does oneget the all brass wads???

Magtech hulls use large pistol primers. Where can one get a simple decapper die and capping die like the old lyman nutcracker???
 

·
Registered
Joined
·
144 Posts
You can use 444 Marlin cases or blown out 303 British cases in most 410 chambers - usually need to slim the 303 rims down a little. Magtech will probably turn out cheaper. To make wads you might be best served to find an appropriate sized punch and cut them out of thick felt / heavy card as you need them - lots cheaper and more convenient than ready made wads.

HTH
Bob
 
1 - 3 of 3 Posts
Top