Shotgun Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter · #1 ·
The operating rod on my grabber keeps popping out of the hole in the bar actuator. I have a universal charge bar and have the other bar actuator on. It was working fine. Maybe I bumped it or something. Any ideas on how to fix? Thanks!!
 

·
Registered
Joined
·
5 Posts
Sportingone: The hook on the end of the rod on all of my grabbers is bent slightly greater than 90 degrees so that it will not come out without detaching the charge bar actuator arm. Perhaps yours is straightened out slightly or the hole in the actuator arm is enlarged? In either case a slight tweaking with a pliers should fix it.
 

·
Registered
Joined
·
7,159 Posts
Sounds like a screw, bolt, nut or something has vibrated loose somewhere.

That MEC pull rod is heavy-duty metal and the chance of its hooked end getting even slightly straightened out would be virtually nil.
 

·
Registered
Joined
·
558 Posts
Could it in the operating rod backwards? Did the snap ring on the bottom come off?
 
1 - 5 of 5 Posts
Top