Shotgun Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
I ordered a new stock for my 686, when I removed the old one I found the threads on the bolt have been pulled. The threads on the reciever are still good. I'd clean up the threads on the bolt if I knew the pitch. It looks like a 12/28, but I'm not sure. I tried Numerich and they don't list the Onyx or at least not that I can find.

Any ideas on this?

Thanks,
Scott.
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #5 ·
Thanks John,

I have found that out already. I didn't know ahead of time, but for some reason I checked, just out of curiousity, and found my stock was cut deeper than the replacement. I really appreciate your info. Thats one of the great things about this site!

Thanks again,

Scott
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top