Shotgun Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
I have been try to adjust my MEC for Remington STS 12ga..
The hulls fired length has varied as much as .05".

Should I group the hulls in specific ranges of length?

What change in length should I change the final crimp setting?
 

·
Registered
Joined
·
12,198 Posts
heath said:
I have been try to adjust my MEC for Remington STS 12ga..
The hulls fired length has varied as much as .05".

Should I group the hulls in specific ranges of length?

What change in length should I change the final crimp setting?
i would just set the machine for the shortest hull, this may give you a swirl on the longer tubes but is no problem
 

·
Registered
Joined
·
17,956 Posts
I agree with Tex! Not a big problem, just make sure the short hulls fully close so shot doesn't roll out. This isn't like centerfire rifle and handgun cases where length is important.

BP
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top