Shotgun Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
549 Posts
Discussion Starter · #1 ·
Does anyone know any method to make a recoil pad slicker so it wont grab cloth while mounting ?
Mike
 

·
Registered
Joined
·
7,201 Posts
Usually it's about wearing loose clothing or to long LOP on the gun. But you may want to try talcum powder it.
 

·
Registered
Joined
·
1,500 Posts
Greyghost: Low-gun skeet shooters put electricians tape over the top 1/3 of the recoil pad...remember just the top third. I do this and it works quite well...slides right in there...makes a HUGE difference.
 

·
Registered
Joined
·
48 Posts
Many of the aftermarket pad guys make spray on products to do this. I use Pachmahr Decelerators which are not sticky so I do not run into this problem. I know that kick-eez and possibly sims make a slicker-upper (technical term) for their too-sticky pads.
Mike
 

·
Registered
Joined
·
549 Posts
Discussion Starter · #5 ·
Thanks I appreciate the suggestions and I think I'll give the electrical tape a shot since I have some handy.
Mike
 
1 - 7 of 7 Posts
Top