Shotgun Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I have three different kinds of new nontoxic's to reload.
1) tungsten bronze at 12 density B, 3, 5's
2) new soft iron tungsten shot that federal loads and sells. BB, 2, 4's.
3) a new tungsten nickle iron at 13.5 density. #6's

I have 12gage 3"&2 3/4 hulls primed and steel powder and hs7 powder. I have loaded some of the 4's 2 3/4 with 34 grains of steel at an 1 1/8 oz load and got 1270 fps and 10700 psi pressure. I think this is good but not great any sugestions?
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #3 ·
Yes I am the conection my company produces it and I invented it its the shot that federal loads. I have produced the tungsten bronze and the high density tungsten nickle iron in small test batches for R&D workups.

I will look up what my wads and primes are and get back to you tomarrow.

Thanks for the help
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #4 ·
I found the info faster than i thought

got them all from balistic products.
Multi-Hull 12ga 3" Hull, 16mm Brass, 7mm Basewad, 209 primer, Green tube
The Ranger Plus, designed for magnum steel shot loads,

Fiocchi 12ga 2-3/4" Hull, 16mm Brass, 7mm Basewad, F616 primer, Clear tube
STS (MG42) 12GA WAD
Cushioned hunting wad for lead, bismuth, steel hunting & target loads and Hevi-Shot.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top