Shotgun Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
8,749 Posts
Discussion Starter · #1 ·
I would like to ha my M2 stock shortened. I'm thinking that a thinner pad might be all I need. Is there an aftermarket pad that would replace the large pad. Polymer stock. I'd like it to [email protected] 13"
 

·
Registered
Joined
·
375 Posts
I looked at this when shopping for my daughter. I could find a few reports of people that shortened the stock, added some wooden blocking, then installed a grind-to-fit pad. I imagine you could go that route.

A safer, but more expensive, route is to replace the stock with a compact version.

Benelli sells a thinner recoil pad, but it only gets the LOP to 13 7/8"
https://www.midwestgunworks.com/page/mgwi/prod/81046
(MGW says it fits M2 Comfortech 12ga and 20ga)

If you buy the compact stock instead, it should get you to 13 1/8" LOP
https://www.midwestgunworks.com/page/mgwi/prod/60502
 

·
Registered
Joined
·
333 Posts
I used the thinner pad on my 12ga and the gun fits perfectly now---not sure if the 12ga and 20ga accessories interchange though?
 

·
Registered
Joined
·
8,749 Posts
Discussion Starter · #5 ·
The thinner pad works perfectly!
 

·
Registered
Joined
·
28 Posts
Keep your eyes out in gunbroker or fleabay for a compact stock. You can sell it when they outgrow and another young shooter will benefit from it ;)
 
1 - 6 of 6 Posts
Top