Joined
·
726 Posts
When I first started reloading 2-3/4" Fiocchi target hulls with steel heads I found out my Mec Grabber was not sizing them down far enough. It sized the brass hulls just fine but not the steel headed hulls. I had 4 flats of shells that would not fit in my Browning O/U.
After adjustibg the collet on my grabber to size the steel hulls down farther I removed the deprime punch on my grabber.
Then I ran those 4 flats of shells through the sizing station on my Mec Grabber. I had no problems resizing those Fiocchi loaded shells with the deprime punch removed.
After adjustibg the collet on my grabber to size the steel hulls down farther I removed the deprime punch on my grabber.
Then I ran those 4 flats of shells through the sizing station on my Mec Grabber. I had no problems resizing those Fiocchi loaded shells with the deprime punch removed.
