Shotgun Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
hey guys, i bought a new 310 about 2 months ago and for the first couple of hunts it has performed great. now, misfire's, doubles, you name it. i sprayed the trigger assembly with carb cleaner and took an air compressor to blow out any loose fragments. now i would like to take the trigger assembly off the gun and clean the guts, but i cannot figure how. the owners manual does not include directions for this. thanks, oh and if you have pix, they would be appreciated.
 

·
Registered
Joined
·
201 Posts
Pull off the stock (long screw under recoil pad and small screw by trigger). All internal parts of trigger will be exposed once the stock is removed. I would be afraid of going much further then that for fear of messing it up worse. If the spray down doesn't fix your problem I would send it in for repair.

Did the first batch of carb cleaner help at all?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top