Shotgun Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
743 Posts
Jampe said:
Ulysses said:
Jampe said:
Are all 870, 1100 and 11-87 cylinder bore barrels true cylindrical from the end of the forceing cone to it's end?
I can't think of any good reason why they would NOT be true cylinder bore if that is what is marked on the barrel. I'm assuming you are referring to fixed choke barrels and not barrels that are threaded for screw-in chokes.

Why would you think that they might not be true cylinder bore? What is it that concerns you?
I have heard that some Russian competition barrels have had some kind of recess choke to improve pattering even on cylinder bore or very close to cylinder bore barrels.

I wish to confirm that a 28" Remington barrel cut to 26" is as good as a factory cylinder bore 26" one, pattern wise.
You state factory cylinder 26" Remington may have made them that long but the ones that I have seen have been shorter.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top