Shotgun Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have an older, 2nd hand 686 with a hard rubber recoil pad. I'd like to upgrade it to a Beretta Gel-Tek pad. The installation looks simple enough but I'm not sure how to remove the old pad. Is it screwed or glued on? Any suggestions greatly appreciated. Also any comments on the Gel-Tek.

Thanks very much.
Paul
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top