Shotgun Forum banner
1 - 12 of 12 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Need Help: White Wing Trap Throws the Clay Target within 20 Feet only: Problem

Any Trap Specialist, Technical & Experienced member please help me out and guide me how to solve this Issue.

My White Wing Trap Made by Do-all Outdoor, Throws the Clay Target not like a Frisbee. But my Machine throws the Clay target in Up & Down direction. As the Machine throws the Clay Target in the air it shakes all the time in the air & clay target travel on 20 feet.

Reply me soonest.
Thank you & waiting.
 

·
Registered
Joined
·
3,671 Posts
Mudpack, it has a bent tray, he's already been on Trapshooters with the issye
 

·
Registered
Joined
·
6,400 Posts
I had an Aerial Assault Doall trap. I bolted stiffeners to the tray to keep it flat. I replaced the arm at least once. I replaced the motor at least once. I replaced the foot switch a couple times. I replaced quite a variety of other parts. Doall did keep supplying parts but I got tired of working on the **** thing. So, I got a Champion Easy bird 6 packer. It is better than the Doall. The Champion is a second rate piece of Chinese junk. The Doall is a third rate piece of Chineese junk. I joined a local range that charges $3.00 a round for practice. It is real hard to settle down and focus on your shooting when all you can think about is when will this piece of crap break down next?
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #8 ·
DO All-Outdoor is the Best Customer Support & A+++ response. Specially the Trap Specialist ERIC at Do All Outdoor.

They have given me the Full Replacement, And dispatch latest Brand New Model Trap Machine.

Thank you Do all Outdoor & Mr. Eric the Trap Specialist too.

Do All-Outdoor the world No #1 Customer Support.
 

·
Registered
Joined
·
11,594 Posts
albatros said:
They sent me a brand new trap too. This was after I replaced almost every part at least once. The brand new trap lasted about a year before it broke down. Best of luck, but don't get your hopes up.
They sent me a new Raven to replace my White Wing(after like you basically replacing everything,some parts more than once :evil: ) And the Raven has needed parts twice in less than a year.Never gotten around to replacing the bad part yet to see if that will fix it.

Sure glad I got my Atlas and no problems at all in a couple of years :)
 

·
Registered
Joined
·
140 Posts
I recently bought the DoAll Raven. With the machine set to its highest angle it only gets about 8' - 10' off the ground. I considered putting larger diameter wheels to increase the angle, but not sure that will fix it. Anyone else experience this?
 

·
Registered
Joined
·
6,400 Posts
My experience was with their Aerial Assault, but, one of my problems was it threw them TOO FAR. I wanted to set it up so that it would throw standard ATA trap targets. I started backing off the main spring to shorten up the throwing distance. But as I got close to where it should be I ended up with the main spring loose and sloppy. Things work a whole lot better if there is always at least some tension on the spring throughout the cycle. The left/right movement of the trap pretty much duplicates the OLD ATA three hole setting. There is no way to adjust for the more modern 2-hole movement.
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top