Shotgun Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
66 Posts
Discussion Starter · #1 ·
I received a parts kit for this gun from Midwest Gun Works and it included a gasket for the magazine tube,or barrel and forestock. However, it does not seem to have a function. It gets chewed up under the magazine cap so I don't think it goes there. There is no groove in the wood for the gasket to seat. Was this model sometimes made without the gasket needed or am I missing some installation procedure?
By the way, I can't log on as a member (otteray)
 
G

·
The forearm spacer sits on the return spring (magazine tube). Between the forearm wood, and the barrel lug. In other words, place the o-ring in the recess in the muzzle end of the forearm, slide the barrel into the forearm, then slide this assembly into the receiver, then tighten the forend nut.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top