Shotgun Forum banner

Browning 725 inflex pad

2.9K views 18 replies 9 participants last post by  Armtx77  
#1 ·
Hey guys

Just purchased a new to me 20ga millers sporting 725. Shot it well right out of the box, but lop is a little long . From the factory it's approx 14 7/8. I was hoping to buy a shorter inflex pad as I was told it's a direct replacement.

Can't seem to find them anywhere in the US. Do they not make these anymore?
Figure I would start there before looking at other brands or cutting the stock.
 

Attachments

#4 · (Edited)

This site is European, but they apparently show Inflex pads in various thickness.

I would love to take 1/4" to 3/8" off of my CXS by swapping out for a thinner pad. The factory Inflex II is 1" thick. Getting a 12mm and 20mm would be nice to play with.
 
#16 ·
I can't tell from the picture but do you have the trigger at the furthest rear position. That worked for my cynergy CX