Here's the other two mods. 1st is the Charging Handle mod. It's the OEM handle with a Polished 45ACP case epoxied on.
Pic1 OEM Charging Handle with epoxied 45 case

Pic2 All Polished up

Next we have the factory OEM Bolt Release. All I do it drill and tap it for a larger button than the original.
Pic1 Bolt release all done

Pic2 lucky for me I found this nickel with a hole in it

Pic3 Here they are together.

 

The sexiest .20cents iv ever spent.

 

Here's the light and shell holder that will be installed. The light is a Feyachi purchased on Amazon. I own four of these lights, I highly recommend them.

Shell Holder was also purchased on Amazon.

 

Here's the light install. The Mlok mount turned red after I heated it. I heated the mount so that it would melt ever so slightly into the plastic handguard.

Then I drilled the mount holes from the mount to the plastic handguard. I used the Mlok hardware in reverse. Once I made sure everything was gonna work I used Red thread locker on the Mlok hardware.

Here's the light and switch mounted a little Blue thread locker was used on the Mlok hardware.

I'm well aware that the Velcro strap will melt if the barrel gets hot enough.

Here's the Shell Holder is held in place using a sticker (double sided tape). Some of these tapes now and days are pretty impressive it's no permanent solution.

Here it is all together
Citadel Bosshog $230
Choate +3 Tube $55
Light $40
Shell Holder $4.50
Bolt release mod .05cents
Charging Handle mod .15cents
Modding Loading Port Free!

Here's what I got for $330, fun little project. This shotgun is still under 500 rounds. It has yet to fail. This gun has seen nuthing but target loads 7.5/8 11/4oz 1200-1250fps, again not 1 failure.

 

Hope it works out for you.
James Reeves always seems to break the Turkish guns.

Sent from my Pixel 3 using Tapatalk

 

They do work I purchased 2. I'm well aware of TFB TV James is a salesman and he's a good one. I think twice about anybody who worships Glocks and believes in Glock Perfection 😆.